| |
|
KRAKEN 52
|
|
|
KRAKEN 52
MAY DEAL on DEAL 5 ARTR almost ready to run. We will supply it with
servos and waterproof switch already fitted so that only your receiver and
battery is needed, at NO EXTRA COST. This deal is available until May
31st.
|
|
|
|
|
|
Circuit(OVAL) races in UK.
52 ins 1340mm long long and normally fitted with 5" wooden
rails although it can be supplied without. This is the only ARTR REAL
RACING BOAT AVAILABLE.
Video of Kraken Deal 4/5
|
|
| All of our racing boats are
made from epoxy and glass or carbon kevlar and are vacuum moulded with
multiple layers of material. This gives a very light and strong moulding
which is far better than normal fibreglass. Do
not confuse these boats with normal fibreglass boats. These are top
quality lightweight epoxy mouldings made with up to 5 layers of
glass or 4 layers of glass one of carbon and kevlar and
slow setting epoxy resin which means no distortion, no gel coat
cracks and they are VERY strong. These boats are hand
laid up in a ceramic mould. The mould and moulding are vacuum
bagged and left in an oven for 16 hours at 50C and then post cured at
25C for 24 hours after removal from the mould. They are then
joined with kevlar or glass and again cured overnight in the oven.
This makes for an extremely strong, stiff and lightweight racing
boat. Carbon kevlar is incredibly difficult to damage. The
engine tank cover is made from epoxy glass to prevent radio problems. |
|
|
 
KRAKEN
Joined hull and deck in epoxy carbon kevlar
with epoxy glass engine cover
. No hardware
|
£395.00
|
| KRAKEN
DEAL
4. Ultimate deal.
Kit
consists of KRAKEN EK vacuum moulded epoxy and carbon/ kevlar joined boat
with TK5 Tiger King Racetuned 27cc racing
engine Full race Tiger King 4 bearing engine 7.6 bhp engine, special
watercooled exhaust adapter, watercooled silenced
stainless steel CS26 tuned pipe,
coil remote relocation kit, bellcrank type throttle linkage, quiet motor mounts,
1/4" flexishaft assembly including aluminium CNC strut, brackets,
tube, drive dog, CNC machined wedge rudder assembly with 2 built in water
pickups, 2 aluminium water outlets, 2 through hull nipples, large radio box with special
rubber bellows, big bore water silicone tube and tygon fuel tube,
stainless steel flexhex coupling, fuel tank, quick release hatch clips, balanced-sharp 3 blade
racing propeller, tube type
aerial, rudder and throttle linkages, turn fins, and tuned pipe mount,
Hull is vacuumed epoxy/carbon kevlar, engine cover is vacuumed
epoxy/glass. This is top quality hardware not seen on any other boat kits.
Normal price £1104.00. Special price £995.00.
|
£995.00
|
|
Kraken DEAL
5 ARTR. PARTLY ASSEMBLED
deal. ARTR Motor
and motor mounts installed plus coupling, shaft, tube, rudder, turn
fins, strut, cowl locks, water outlets are all fitted. (some parts
removed for shipping) Consists
of KRAKEN EK epoxy and carbon and kevlar vacuum joined boat with TK5
Tiger King Racetuned 27cc racing engine Full race Tiger King 4 bearing
engine 7.6 bhp engine, watercooled
exhaust manifold, watercooled silenced stainless steel CS26 tuned pipe, coil
remote fitting kit,
bellcrank type throttle linkage, quiet motor mounts, 1/4" flexishaft
assembly including aluminium CNC strut, brackets, tube, drive dog, CNC
machined wedge rudder assembly with 2 built in water pickups, 2 aluminium
water outlets, 2 through hull nipples, large radio box with special rubber bellows and servo mount
plate, big bore water silicone tube and tygon fuel tube, balanced and
sharp metal 3
blade racing propeller, tube type aerial, rudder and throttle
linkages, turn fins and tuned pipe mount. This is top quality hardware not seen on any other boat
kits. Hull is vacuumed epoxy/carbon kevlar, engine cover is vacuumed
epoxy/glass. Normal price £1304.00. Special price £1150.00.
Upgrade to TK6 29cc engine TK6
S-29 £34.00
Alternative with Tuned Zenoah 32cc £1250.00
|
£1150.00
|
|
|
Kraken/Sigma cover
|
|
Kraken old cover
 |
|
Kraken semiscale cover
 |
|
| . |
. |
| Nice KRAKEN 2019 built
by Stephen Pattle with 29cc tuned Tiger King |
. |
 |
. |
|
. |
| Nice KRAKEN 2019 built
by Aaron Ellwood with optional radio controlled stinger |
. |
 |
. |
|
