PMB Model Boats   
email   phone 07842 634090
Home  GAS Engine Tuned Pipes    Parts Hardware 
Zenoah Engine Spares    Tiger King Marine engines  Zenoah Marine Engines  

Gas engine accessories for Zenoah 260PUM, 300PUM, 320PUM, 350PUM, Tiger King 27 EVO, Tiger King 29 EVO, CY, CRRC, RCMK.
ZEN516 ALUMINIUM INSULATOR BLOCK/carb flange with fibre gaskets. Block is machined with raised edges to prevent the gaskets being distorted. Better performance from the smoother intake tract and no more distorted flanges. wpe1.jpg (11463 bytes)

ZTK519 NEW  for June 2018 ZTK519 Improved BIG BORE CARB KIT AND ALUMINIUM 90 degree INSULATOR BLOCK with complete bellcrank type linkage kit to fit Zenoah, Tiger King, RCMK and other motors.
This is a REAL 15.5mm big bore carb with linkage and insulator block that rotates the carb 90 degrees. New design carb has a maximum opening stop and a low speed throttle stop adjusting screw. 
This 15.5mm bore carb which has no butterfly and so has far better flow figures than a normal bored out Walbro carb. This carb has an aluminium barrel for strength plus it has a new top cover with anodised aluminium ramp to remove any wearing problems that usually occur on this type of carb. We have modified the popoff valve pressure to provide more fuel at high rpm. The improved throttling/torque and increase in peak power with this carb on a modified or stock engine is immediately apparent. The kit comprises modified big bore carb, throttle bellcrank type link, insulator block and gasket and is a direct replacement for the original insulator block and butterfly type carb (644 or 257)


 THIS IS NOT A WYK33 CARB and the aluminium barrel and linkage will not fit a WYK33. This carb has an aluminium barrel and a bigger bore than the WYK33.

  wpe7A.jpg (80418 bytes)   wpe89.jpg (145577 bytes)

wpe8B.jpg (51965 bytes)

ZTK517 Barrel carb used in ZTK519 only. This has the extra nipple for direct crankcase pulse pressure and the standard pulse pressure hole.



wpe6C.jpg (95619 bytes)
ZTK518 Big bore 18mm Tillotson type carb modified for use on 320PUM engines.



wpe4.jpg (50041 bytes)
ZTKFL1 Flange and gaskets for ZTK519 only



wpe71.jpg (93751 bytes)
ZEN524 Throttle linkage, bellcrank type  for pushrod operation on Zenoah and Tiger King engines.. CNC machined aluminium, easy to fit.  A coil relocator must be used with this item. wpe9B.jpg (462953 bytes) wpe9D.jpg (117354 bytes)
ZEN525 Pushrod for bellcrank type throttle linkages. 2 x 2mm pushrods threaded at one end with small strong balljoints and stainless steel pushrod connector. wpe2.jpg (8622 bytes)
ZEN526 Aluminium throttle arm for Walbro carbs  wpeC3.jpg (30327 bytes)
SPECIAL OFFER FOR Jan to April 2010  25.00 including shipping to anywhere in the world.
zenoah twostroke tuning software





wpe2.jpg (19204 bytes)

ZEN 527 CLUTCH. RC boat clutch assembly with round 1/4" flexshaft coupling to fit  Zenoah 260PUM to 300PUM, Tiger King, RCMK and Sikk engines. This clutch will allow the fitting of standard engine mounts. wpe4.jpg (10248 bytes)

ZEN528 CLUTCH and WATERPUMP assembly ready to fit. 
Complete heavy duty centrifugal clutch and waterpump for Tiger King, Zenoah 260PUM to 300PUM, RCMK and Sikk engines. The clutch disengages at low rpm to allow the boat to stop and the waterpump feeds water around the engine to prevent overheating.   
wpe5C.jpg (10248 bytes)     wpe67.jpg (29689 bytes)


ZEN529A Waterpump with single input/output wpe67.jpg (29689 bytes)

ZEN530 Tygon genuine fuel tubing 3.2mm inside diameter. This is the very soft flexible type of tubing suitable for petrol (gas). 950mm wpe1.jpg (46880 bytes)

ZEN531 Starter pulley for use with starter belt and electric starter for Zenoah and Tiger King. Replaces the pullstart and makes life easy.  Use with 24volt starter and starter belt .wpe85.jpg (24613 bytes)

ZEN532 Zenoah aluminium quick change quiet motor mount fits 5" rails. This motor mount will also fit in boats that have no rails. For Zenoah up to 30cc, Tiger King zenoahmountht4.jpg (2879 bytes)
ZEN533  CNC machined aluminium quiet motor mount fits 5" rails for Zenoah up to 30cc and Tiger King. Contains rubber mounts, mounting plates and all screws etc.

 CNC-Machined-Quick-Release-ENGINE-MOUNT-ZENOAH-QD-RCMK-K30S-RC-Model-Boat-Gas 32.95

ZEN534 CNC VS3 high quality machined aluminium quiet motor mount fits 5" rails for Zenoah up to 30cc or Tiger King engines. Also SUITABLE FOR FSRV BOATS. Contains rubber mounts, mounting plates and all screws etc.    wpe90.jpg (23588 bytes)
ZEN535 CNC  260PUM and 320PUM VS2 machined aluminium quiet motor mount   fits 5" rails  Contains rubber mounts, mounting plates and all screws etc.    wpe74.jpg (14555 bytes)
ZEN536 CNC  320PUM VS3 machined aluminium quiet motor mount  fits 5" rails  Contains rubber mounts, mounting plates and all screws etc.   wpe97.jpg (32006 bytes)
ZEN540 CNC aluminium coil relocator to fit Zenoah, RCMK, Tiger King. wpeE.jpg (17538 bytes)  wpe8.jpg (35183 bytes)
EE8A Manual geared fuel pump.  Suitable for nitro or gas.  
wpe1.jpg (12935 bytes)
ZEN550 1 litre of Shell Advance racing M oil for all Zenoah, RCMK etc.  UK SALES ONLY wpe58.jpg (18406 bytes)

Hit Counter 2206 

WE SHIP WORLDWIDE contact     Phone.  UK  07842 634090  international  00447842 634090.       PMB,  4, Harvey Court, Harvey Lane, Golborne, Cheshire, WA33RX  England.   Model boats of all types including FSRV, FSRH, FSRO Offshore,  Deepvee, fast electric, cats, zenoah gas boats.     Visa LogoMastercard LogoMaestro LogoElectron Logo